General Procedures and Functional Checks
4-10 LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
Check System Date and Time (continued)
Move the cursor to OK and press the Cursor Key to select OK.
The system enters scanning mode.
Figure 4-4. Cursor key
Check the system date and time. If it is incorrect, follow below
steps to reset the system date and time.
1. Enter Utility -> System -> General -> Date/Time.
2. Reset the system date and time.
3. Select Apply and select OK.
4. Select Save.
To Next Page
Loading...
Need help?
General
