GE LOGIQ e

General Procedures and Functional Checks
4-44 LOGIQ e – Basic Service Manual
5461614-100 English Rev. 6
Cineloop Check
Introduction
A cineloop is a sequence of images recorded over a certain time
frame. When using ECG the time frame can be adjusted to
cover one or more heart cycles. When frozen, the System
automatically displays the cineloop boundary markers on either
side of the last detected heart cycle.
Activating CINE
Press Freeze, then roll the Trackball to activate CINE. To start
CINE Loop playback, press Run/Stop. To stop CINE Loop
playback. press Run/Stop.
Adjust the Cineloop controls
Quickly Move to Start/End Frame
Press First to move to the first CINE frame; press Last to move
to the last CINE frame.
Start Frame/End Frame
Press the Start Frame Two-Button Softkey to move to the
beginning of the CINE Loop. Adjust the Start Frame up/down
Two-Button Softkey upward to move forward through the CINE
Loop. Adjust the Softkey downward to move backward through
the CINE Loop.
Press the End Frame Two-Button Softkey to move to the end of
the CINE Loop. Adjust the End Frame up/down Two-Button
Softkey upward to move forward through the CINE Loop. Adjust
the Softkey downward to move backward through the CINE
Loop.
Adjusting the CINE Loop Playback Speed
Adjust the Loop Speed up/down Two-Button Softkey to
increase/decrease the CINE Loop playback speed.
Moving through a CINE Loop Frame By Frame
Adjust the Frame by Frame up/down Two-Button Softkey to
move through CINE memory one frame at a time.