Revision C MAC 1200/1200 ST 8-13
2012250-021
Stress Tests: Ergometers with Remote Start Pulse
If the speed is 0 in one of the stages, the treadmill switches off and
can only be restarted with .
If the treadmill is stopped with or with the emergency stop
button, the speed and grade readout is “**.*”. Wait until this readout
disappears before restarting the treadmill with . Also remember
to reset the emergency stop button.
When you press or , the program enters the manual mode
and the phase name is given as Manual. For safety reasons, the
program maintains the current stage and the button is
inactive. You can only control the test manually with the and
buttons (speed, grade). When you push , the program
increments to the next stage and a stage report is printed. With
you advance to the next phase.
Program Sequence for Treadmill Test
Start
Stop
Start
Alt
Config
Ergo
Arrhy
Alt
Start
035A
Select Stress
Test Mode
Select protocol.
Check report
interval.
Start treadmill.
Automatic when
last stage is
completed, or
manual
Recovery Phase
Exercise Phase
Pre-Test
When analyzing ST
segment or taking BP,
wait for first results to
be displayed.
To Next Page
Loading...
Need help?
General
