EasyManuals Logo

GE MAC 1200 ST Operator's Manual

GE MAC 1200 ST
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #148 background imageLoading...
Page #148 background image
10-24 MAC 1200/1200 ST Revision C
2012250-021
System Setup: System Setup
Default mode
This is the operating mode the unit defaults to after power-up:
[Automatic].
Language
To select the language.
Enable Password Protection
Select Yes to protect the setup menu with a password. You will be asked
to enter a password and to repeat it. Then password protection is active.
To change the password (only possible when password protection is
active), do the following.
1. Select menu item Enable password.
2. Enter the old password.
3. Enter the new password.
4. Repeat the new password.
Test Data
Used for demonstration purposes (yes). It should be set to [no] (default)
for proper clinical use.
Restore Defaults
Selecting Yes will restore the factory default settings (including the
defaults of the three operating modes).
The electrocardiograph must be switched off and on again for the new
settings to become effective.
Print Configuration Lists
Selecting Yes will display a menu with all available configuration lists.
All lists
System Setup/Communication/Peripheral Devices/Patient Data

Table of Contents

Other manuals for GE MAC 1200 ST

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE MAC 1200 ST and is the answer not in the manual?

GE MAC 1200 ST Specifications

General IconGeneral
BrandGE
ModelMAC 1200 ST
CategoryMedical Equipment
LanguageEnglish

Related product manuals