5-12 MAC 1200/1200 ST Revision C
2012250-021
Automatic Mode Recording: ECG Transmission
ECG Transmission
127(
Observe the safety information given in Chapter 3, “Connecting
Peripheral Equipment” .
Resting ECGs acquired in Automatic mode can be transmitted to
CardioSys/CardioSoft or to a MUSE CV system. The units can either
communicate via modem or directly via a connection cable (see “Direct
Transmission” on page 5-16).
General Considerations
The status of transmission progress is indicated on the display with
message text, e.g., “Transmitting 1 of 1,” or “Transmitting 2 of 6.”
With the transmission can be stopped.
ECGs that were successfully transmitted are identified with the
letter S (for “Sent”).
After the selected ECG records have been successfully transmitted, a
confirmation message displays, e.g. “6 of 6 ECG records successfully
transmitted.”
All ECG records are time stamped (hours, minutes, and seconds). To
view a record’s time stamp, highlight it. Then press + . Use
to scroll right to see the time stamp.
Batch Transmission
The MAC 1200/1200 ST unit can send all untransmitted records in a
batch transmission.
1. Activate the storage program by simultaneously pressing and
. (Press the button first and hold it depressed.)
2. Select Send All Unsent Records. Confirm your choice with .
The message Initializing transmission is displayed, and the option to
cancel the transmission is provided.
To Next Page
Loading...
Need help?
General
