GE MiCOM P40

Module 60
Check Sync Signals
(CB1)
VTS Fast Block
F out of Range
Sys checks CB1
CB1 CS1 Status
CB1 CS1 Enabled
CB1 CS2 Status
CB1 CS2 Enabled
MCB/VTS
MCB/VTS CB1 CS
VAN
VBN
VCN
VAB
VBC
VCA
VBus1
CB1 CS1 SlipF>
CB1 CS1 OK
CB1 CS2 OK
CB1 CS1 SlipF<
CB1 CS2 SlipF>
CS Vbus>
CB1 CS2 SlipF<
CS Vline>
CS Vline<
CS Vbus<
CB1 CS1 Vl>Vb
CB1 CS1 Vl<Vb
CB1 CS1 AngHigh+
CB1 CS1 Fl>Fb
CB1 CS1 Fl<Fb
CB1 CS1 AngHigh-
CB1 CS2 AngHigh+
CB1 CS2 Fl>Fb
CB1 CS2 Fl<Fb
CB1 CS2 AngHigh-
CB1 CS AngRotACW
CB1 CS AngRotCW
SChksInactiveCB1
CB1 CS2 Vl>Vb
CB1 CS2 Vl<Vb
Module 62
Pole Discrepancy
CB1 AR Lockout
CB1 LO Alarm
Pol Disc CB1 Ext
CB1 AR 1p InProg
CB1 Open A ph
CB1 Open B ph
CB1 Open C ph
CB2 AR Lockout
CB2 LO Alarm
Pol Disc CB2 Ext
CB2 AR 1p InProg
CB2 Open A ph
CB2 Open B ph
CB2 Open C ph
Pole Discrep CB1
Pole Discrep CB2
Module 63
CB Trip Conversion
Trip Inputs A
Trip Inputs B
Trip Inputs C
CB1Tripping Mode
AR Force CB1 3P
Force 3PTrip CB1
CB1 Trip I/P 3Ph
CB2Tripping Mode
AR Force CB2 3P
Force 3PTrip CB2
CB2 Trip I/P 3Ph
Pole Dead A
Pole Dead B
Pole Dead C
CB1 Trip OutputA
CB1 Trip OutputB
CB1 Trip OutputC
CB1 Trip 3ph
CB2 Trip OutputA
CB2 Trip OutputB
CB2 Trip OutputC
CB2 Trip 3ph
Any Trip
2/3 Ph Fault
3 Ph Fault
Module 61
Check Sync Signals
(CB2)
VTS Fast Block
F out of Range
Sys checks CB2
CB2 CS1 Status
CB2 CS1 Enabled
CB2 CS2 Status
CB2 CS2 Enabled
MCB/VTS
MCB/VTS CB2 CS
VAN
VBN
VCN
VAB
VBC
VCA
VBus1
CB2 CS1 SlipF>
CB2 CS1 OK
CB2 CS2 OK
CB2 CS1 SlipF<
CB2 CS2 SlipF>
CS Vbus2>
CB2 CS2 SlipF<
CS Vbus2<
CB2 CS1 Vl>Vb
CB2 CS1 Vl<Vb
CB2 CS1 AngHigh+
CB2 CS1 Fl>Fb
CB2 CS1 Fl<Fb
CB2 CS1 AngHigh-
CB2 CS2 AngHigh+
CB2 CS2 Fl>Fb
CB2 CS2 Fl<Fb
CB2 CS2 AngHigh-
CB2 CS AngRotACW
CB2 CS AngRotCW
SChksInactiveCB2
CB2 CS2 Vl>Vb
CB2 CS2 Vl<Vb
V03393-10
VBN
VAN
VCN
VAB
VBus
VCA
VBC
VBN
VAN
VCN
VAB
VBus
VCA
VBC
Figure 148: Autoreclose System Map - part 10
4.2
AUTORECLOSE INTERNAL SIGNALS
The following table lists all the internal signals used in the CB control and Autoreclose logic system:
Signal Name
Source Destination Description
3PDTCOMP 3-phase AR Dead Time (25) 3-phase AR Dead Time (25) Three phase dead time complete
ARDisabled AR Enable (5)
Reset CB Lockout (57)
Force 3-phase Trip (10)
CB1-pole / 3-pole trip (13)
AR Reset Successful (37)
Overall autoreclosing disabled
BARCB1 Autoreclose Lockout (55) Leader/Follower (7) Block Autoreclose for CB1
Chapter 11 - Autoreclose P446SV
272 P446SV-TM-EN-1