1–2 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
OVERVIEW CHAPTER 1: OVERVIEW
1.1.2 Power and Ground
The Multinet4 can be ordered with a high (90 -250 VAC or VDC) or Low (24-48 VDC) voltage
power supply. The connection point for the power supply is located at the rear of the
chassis. The rear face also contains the primary ground stud and labels including serial
number, model number, and port and power specifications, as illustrated in the figure
below.
For detailed power specifications see Table 1–2:: Environmental Specifications.
FIGURE 1–2: Rear View
1.1.3 Indicators
The operational status of the ports of the Multinet4 is indicated by LEDs located near the
physical ports on the front of the Multinet4, as illustrated in FIGURE 1–1: Front View, and a
bank of LEDs on the top of the chassis, as illustrated in FIGURE 1–3: Top View.
FIGURE 1–3: Top View
To Next Page
Loading...
