GE Multinet 4 - The Ethernet Command

5–8 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
THE CLI AND PROTOCOL MONITOR CHAPTER 5: THE CLI AND PROTOCOL MONITOR
For more information see the descriptions of system configuration in section 4.2.11:
Configuration.
5.2.2.3 The Ethernet Command
The table below explains the commands available for managing and monitoring Ethernet
ports when the MN4(ethernet)# prompt is displayed or from the MN4# prompt using an
ethernet prefix.
For example:
MN4# ethernet show all port status
or
MN4(ethernet)# set port e1 flow enabled
show show Display the names, versions, and status of
configuration files.
switch switch
filename Switch from the current configuration file to the
configuration file specified by
filename.
write write
filename Create a new configuration file named filename.
After entering
write filename Return you are
prompted to enter an XML configuration. Enter a valid
configuration and press Return twice to write the new
configuration file to disk.
Table 5–5: CLI config Commands
Command Synopsis Description