4–12 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
SYSTEM ADMINISTRATION CHAPTER 4: SYSTEM ADMINISTRATION
4.2.6.3 SNMP: Trap Stations
This screen enables you add trap stations (up to a total of 4) and to view and edit the
parameters of existing trap stations. A trap station is a destination to which SNMP traps
are sent.
FIGURE 4–10: Administration: SNMP: Trap Stations
The table below describes the parameters you can view and edit in the SNMP: Trap
Stations screen.
Existing Stations Table
IP Address: This table lists the IP addresses of management stations that
have been configured in the system.
Delete: Set the Delete checkbox in a row and click Apply Settings to
delete that management station
.
Table 4–10: SNMP: Trap Stations
Field Name Field Value
IP Address: The Internet Protocol address of the trap station. You can
specify up to 4 trap stations.
Table 4–9: SNMP: Management Stations
Field Name Field Value
To Next Page
Loading...
