GE Multinet 4 - Protocol Monitor Output Example

5–14 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
THE CLI AND PROTOCOL MONITOR CHAPTER 5: THE CLI AND PROTOCOL MONITOR
5.2.2.7 Protocol Monitor Output Example
For an Ethernet port with the Protocol Monitor configured as shown in the figure below:
FIGURE 5–2: Protocol Monitor Example Configuration
Sample output is illustrated in the figure below.
FIGURE 5–3: Protocol Monitor Example Output
start start Begin monitoring. Once the command has been issued, packets will
be displayed. You can pause the display by pressing the Enter key.
You can abort the monitor and return to the CLI by pressing the ESC
key:
Table 5–9: Protocol Monitor Command Set
CMD Synopsis Description