GE Multinet 4 - The Vlan Command

5–24 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
THE CLI AND PROTOCOL MONITOR CHAPTER 5: THE CLI AND PROTOCOL MONITOR
5.2.2.15 The vlan Command
The table below explains the commands available for viewing and managing VLANs when
the MN4(vlan)# prompt is displayed or from the MN4# prompt using a
vlan prefix.
For example:
MN4# vlan add vid 22 name substation_22
or
MN4vlan)# show all ports
Table 5–16: CLI terminal Commands
Command Synopsis Description
set set lines | paging Control the display of the CLI terminal.
Available parameters are:
• lines n – Where n is a number in the range of 1 -
100. This is the maximum number of lines to
display in the terminal window on execution of a
CLI command.
Default value = 24
•
paging y|n – Control scrolling in the CLI terminal
window:
— If y is specified output will display one
"page" at a time; that is the scrolling of
information will pause at the number of
lines specified by the lines parameter and
resume after a key is pressed.
— If n is specified output will scroll to the
screen without pausing until command
output is complete.
show show Show lines and paging settings.
Table 5–17: CLI session Commands
Command Synopsis Description
add add vid n name vlan_name Add a VLAN with VID n (a number in the range 1 -4094)
and the name
vlan_name (up to 24 printable
characters).
delete delete vid n Delete the VLAN identified by VID n.
edit edit vid n name new_name Change the name of the VLAN identified by VID
n to
the name specified in
new_name (up to 24 printable
characters).