CHAPTER 4: SYSTEM ADMINISTRATION SYSTEM ADMINISTRATION
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 4–37
Host Unreachable Serial port Sx reports that the host at ipaddr is unreachable.
The terminal server channel for Serial port Sx is configured to call out
to a remote host at IP address ipaddr but the system has no route to
the destination address.
Connection
Refused
Serial port Sx reports that the connection to the host at ipaddr
(tcpport) was refused.
The terminal server channel for Serial port Sx is configured to call out
to a remote host at IP address ipaddr and TCP port tcpport, but the
host actively refused the connection.
Lost Connection Lost connection with host ipaddr (tcpport) on channel Sx.
The terminal server channel for Serial port Sx was connected but the
system lost contact with the remote host. The remote host may have
actively torn down the connection or the connection may have been
flagged as dead due to lack of response to TCP keep-alive messages.
Handshake Failed Serial port Sx reports that the host at ipaddr (tcpport) did not respond
to the SSL handshake.
The terminal server channel for Serial port Sx is configured for SSL
security. During the authentication phase of the SSL handshake, the
peer did not respond. This is likely because the connection was made
to a non-SSL enabled host.
See the SSL troubleshooting section (
Section 7.9:
Troubleshooting Terminal Server SSL Connections
) for
more information.
Handshake
Problem
Serial port Sx experienced a problem (problemdescription) while
connecting to the host at ipaddr (tcpport).
The terminal server channel for Serial port Sx is configured for SSL
security. During the authentication phase of the SSL handshake, a
problem occurred and the handshake did not complete. Possible
problems include:
• unknown protocol
• no shared cipher
Table 4–23: Logged Events
Event Description
To Next Page
Loading...
