CHAPTER 5: THE CLI AND PROTOCOL MONITOR THE CLI AND PROTOCOL MONITOR
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 5–5
5.2.2 Basic and Specific Commands
Type a question mark ("?") at the MN4# prompt to see a list of global and basic commands
and a brief description of each:
Table 5–2: CLI Global Command
Command Description
exit When you are in a basic command mode, such as
Multinet4(ip)#, the exit command returns you to the main CLI
prompt - Multinet4#.
help (or ?) Display options available in current mode.
history Display previous command line input.
logout Log out of the system and display the Login prompt.
reboot Shutdown and restart the system.
restore Restore configuration to default settings.
revert Undo changes since last save.
save Save current configuration.
whoami Show current user information.
Table 5–3: Basic CLI Commands
bridge – ethernet bridge management
config – configuration file management
ethernet – ethernet port management
ip – internet protocol management
log – event log management
monitor – traffic monitoring and analysis
ping – ping network utility
rstp – rapid spanning tree protocol
session – user session management
ssh – secure shell management
sw – software upgrade
system – system information
terminal – terminal settings
To Next Page
Loading...
