GE Multinet 4 - Web Server

CHAPTER 4: SYSTEM ADMINISTRATION SYSTEM ADMINISTRATION
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 4–101
4.8.4 Web Server
This screen enables you to configure security settings on the system's embedded web
server.
FIGURE 4–63: Security: Web Server
The table below specifies the values you can view and edit in the Security: Web Server
screen.
Table 4–64: Web Server
Field Name Field Value
Mode: Indicates if the server accepts non-secure HTTP requests. This
parameter takes the following values:
• Allow HTTP The server accepts requests on port 80 (http://)
or on port 443 (https://).
• SSL Only: The server will only allow connections over SSL.
Any requests sent to port 80 (http://) will be re-
directed to the https://URL (Default).