4–100 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
SYSTEM ADMINISTRATION CHAPTER 4: SYSTEM ADMINISTRATION
The table below describes the fields in the Serial/SSL screen.
Table 4–63: Serial/SSL
Field Name Field Value
Port ID: A unique identifier for the serial port being configured.
Enable Security: Enable or disable the use of SSL on this port.
Allowed Ciphers: This parameter specifies the cipher suites to be allowed on a
port.
You can select one of the following standard suites:
• SSL_RSA_WITH_RC4_128_MD5
• SSL_RSA_WITH_RC4_128_SHA
• SSL_RSA_WITH_DES_CBC_SHA
• SSL_RSA_WITH_3DES_EDE_CBC_SHA
• TLS_RSA_WITH_RC4_128_MD5
• TLS_RSA_WITH_RC4_128_SHA
• TLS_RSA_WITH_DES_CBC_SHA
• TLS_RSA_WITH_3DES_EDE_CBC_SHA
• TLS_RSA_WITH_AES_128_CBC_SHA
• TLS_RSA_WITH_AES_256_CBC_SHA
In addition, the following groups, which are combinations of the
standard cipher suites, may be specified:
• ANY - any supported cipher suite
• ANY_STRONG - any supported cipher suite with at least
128 bit keys
• ANY_STRONG_SSL - any strong cipher suite that uses SSLv3
• ANY_STRONG_TLS - any strong cipher suite that uses TLSv1
• ANY_AES - any cipher suite that uses AES
Require
Authentication?
If this option is set to "Yes", the connected SSL peer must
provide a valid and trusted certificate or the SSL handshake will
fail.
Assigned Key: Use this RSA key and matching certificate during the SSL
handshake/negotiation.
To Next Page
