GE Multinet 4 - Mounting in a 19 Rail System - Conventional Mounting

2–6 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
GETTING STARTED CHAPTER 2: GETTING STARTED
FIGURE 2–1: Top View: 19” Rail Conventional and Reverse Mounting
2.3.1.3 Mounting in a 19” Rail System - Conventional Mounting
The brackets for mounting in a 19-inch rail system attach with two screws to the screw
holes located toward the front of the Multinet4. You can adjust the depth of the device
within the mounting system to four positions:
• By your selection of which pair of screw holes on the short side of the bracket (that
is, the side that attaches to the Multinet4) to use.
• By setting the long side of the bracket (that is, the side that attaches to the rail
system) toward the front of the Multinet4 or toward the rear.