GE Multinet 4 - The System Command; The Terminal Command

CHAPTER 5: THE CLI AND PROTOCOL MONITOR THE CLI AND PROTOCOL MONITOR
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 5–23
5.2.2.13 The system Command
The table below explains the commands available for basic system information
management when the MN4(system)# prompt is displayed or from the MN4# prompt
using a
system prefix.
For example:
MN4# system set location North Andover
or
MN4(system)# show
For more information see the description of basic system information management in
section 4.2.2: System Information.
5.2.2.14 The terminal Command
The table below explains the commands available for terminal settings when the
MN4(terminal)# prompt is displayed or from the MN4# prompt using a
terminal prefix.
These commands enable you to control the display of CLI command output in your virtual
terminal window.
For example:
MN4# terminal set lines 18
or
MN4(terminal)# show
Table 5–15: CLI system Commands
Command Synopsis Description
set set name | location
| contact
The available parameters are:
• name sysname – Where sysname is a name for the
system under configuration.
• location placename – Where placename is the
name of the place where the system under
configuration is located.
• contact identinfo – Where identinfo is a name
or contact information for a person responsible
for management of the system under
configuration.
show show addresses Display basic system information.