GE Multinet 4 - The Ping Command; The Rstp Command

CHAPTER 5: THE CLI AND PROTOCOL MONITOR THE CLI AND PROTOCOL MONITOR
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 5–15
5.2.2.8 The ping Command
The table below explains the ping command. This command is available from the MN4#
prompt.
5.2.2.9 The rstp Command
The table below explains the commands available for managing and monitoring Rapid
Spanning Tree Protocol (RSTP) functionality when the MN4(rstp)# prompt is displayed or
from the MN4# prompt using an
rstp prefix.
For example:
MN4# rstp set bridge hello 20
or
MN4(rstp)# show port e1 settings
Table 5–10: CLI ping Command
Command Synopsis Description
ping ping ipaddress Test the accessibility of another device at ipaddress.