5–16 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
THE CLI AND PROTOCOL MONITOR CHAPTER 5: THE CLI AND PROTOCOL MONITOR
Table 5–11: CLI rstp Commands
Command Synopsis Description
set set bridge | port
portnum params...
Specify RSTP settings for a bridge or port, where portnum
is an Ethernet port designated E1, E2, etc.
The available bridge parameters are:
• age n – Specify the maximum age of STP
information before discard in a range of 6 - 40
seconds.
•
cstyle 16-bit | 32-bit – Specify 16-bit (STP)
cost style or 32-bit (RSTP) cost style.
• delay n – Specify a delay before forwarding state or
topology change information in a range of 4 -
30 seconds.
•
hello n – Specify interval between transmission of
configuration BPDUs.
• mode enable | disable – Enable or disable
RSTP on this bridge.
•
priority n – Specify a priority value for this bridge
in the range of 0 (highest priority) to 65535,
The available port parameters are:
• mode edge | legacy | point | auto –
Specify one of the following modes:
— edge – For an RSTP-enabled port
connected to an end system.
— legacy – For a port that uses STP only.
— point – For an RSTP-enabled port
connected to another switch.
— auto – The port automatically
determines the correct mode based on
received BPDUs.
To Next Page
Loading...
