CHAPTER 4: SYSTEM ADMINISTRATION SYSTEM ADMINISTRATION
MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL 4–31
4.2.11 Configuration
The Configuration: Files and the Configuration: Defaults screens shown below, allow you to
make system-wide changes by installing a new system configuration file or by returning to
factory defaults.
4.2.11.1 Configuration: Files
This screen enables you to install and manage configuration files.
When the system is shipped from the factory, it contains a single current configuration file
with factory default values called "config0.xml". Subsequent configuration files will contain
the administrator’s saved settings.
FIGURE 4–21: Administration: Configuration: Files
The table below describes the tasks you can perform in the Configuration Files screen.
Table 4–22: Configuration Files
Field Name Field Value
The Install Form
File: To install a configuration file:
1. Browse to a file on you local system, or enter the full
path name of a configuration file.
2. Click
Upload.
Browse: Browse to select a configuration file on your local system.
Upload: Click this button to make the file specified in pathname the
“Current” configuration file. If the configuration is valid the
system is reconfigured according to the contents of the file.
To Next Page
Loading...
