GE Multinet 4 - The Log Command

5–10 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
THE CLI AND PROTOCOL MONITOR CHAPTER 5: THE CLI AND PROTOCOL MONITOR
For example:
MN4# ip set address vid2 192.168.1.100 255.255.255.0
or
MN4(ip)# show addresses
Table 5–7: CLI Ip command
5.2.2.5 The log Command
Table 5–8 explains the commands available for event log management when the
MN4(log)# prompt is displayed or from the MN4# prompt using a
log prefix.
For example:
MN4# log delete 20080315015451.log
or
MN4(log)# dump 20080307004406.log
Command Synopsis Description
set set address|gateway
|management-vlan
• address parameter to configure the system IP
address. Where parameter can be:
• ipaddress – A valid IP address.
• netmask – A valid subnet mask.
• gateway parameter - Sets the IP address of the
default gateway. IP packets are sent to the default
gateway when the destination IP address of the
packet is on a subnet other than the local subnet.
Where parameter can be:
• ipaddress – A valid IP address.
• management-vlan parameter - Sets the VID of the
VLAN from which management functions and
serial encapsulation services may be accessed.
Where parameter can be:
• default – Set to the default VLAN. VID1.
show show arp|settings • arp - Displays the ARP table. The ARP table
contains the known mappings between IP and
MAC addresses.
• setting - Displays the currently configured IP
address, subnet mask, default gateway, and
management VLAN.