4–46 MULTINET4 MULTI-PORT SERIAL SERVER & MANAGED SWITCH – INSTRUCTION MANUAL
SYSTEM ADMINISTRATION CHAPTER 4: SYSTEM ADMINISTRATION
Media Type: Enables you to force a speed and duplex setting on an Ethernet
port or set the port to auto-negotiate mode. Only speed/duplex
settings appropriate for the particular interface type are
allowed:
• Auto (10/100BaseTX) (default for 10/100T)
• 10T Half (10/100BaseTX)
• 10T Full (10/100BaseTX)
• 100TX Half (10/100BaseTX)
• 100TX Full (10/100BaseTX)
• 100FX Full (100BaseFX) (default for 100FX)
Flow Control: This parameter applies to full duplex ports only. Flow control is
optionally implemented using the 802.3
x specification for
PAUSE packets. When congested, the switch will send PAUSE
packets to attached devices to request temporary suspension
of transmission of further frames. The following values may be
selected:
•Enabled
• Disabled
Default value = Disabled
Table 4–28: Ethernet: Ports: Settings
Field Name Field Value
To Next Page
Loading...
