Chapter 3. CPU Configuration
114 PACSystems* RX7i, RX3i and RSTi-EP CPU Reference Manual GFK-2222AD
Day Light
Savings Time
(DST)
RX3i CPE302/CPE305/CPE310/CPE330/CPE400 CPUs only. Activates Day Light Savings
Time (DST) settings for the controller. Allows you to select appropriate local start and end
times for Day Light Savings Time.
Choices:
Disabled: Day Light Savings Time settings are not active.
Enabled: Day Light Savings Time settings are active and configurable.
Default: Disabled.
3.2.2 Modbus TCP Address Map
This read-only tab displays the standard mapping assignments between Modbus address space and the
CPU address space. Ethernet modules and daughterboards in the PACSystems controller use Modbus-
to-PLC address mapping based on this map.
The Modbus protocol uses five reference table designations:
0xxxx Coil Table. Mapped to the %Q table in the CPU.
1xxxx Input Discrete Table. Mapped to the %I table in the CPU.
3xxxx Input Register Table. Mapped to the %AI register table in the CPU.
4xxxx Holding Register Table. Mapped to the %R table in the CPU.
6xxxx File Access Table. Mapped to the %W table in the CPU.
Lists the beginning address of the mapped region.
Lists the ending address of the mapped region. For word memory types (%AI, %R and %W)
the highest address available is configured on the Memory tab.
Lists the memory type of the mapped region.
Displays the length of the mapped region.
To Next Page
Loading...
Need help?
General
