GE PACSystems RX7i Reference Manual

Chapter 1. Introduction
GFK-2222AD April 2018 3
Rev
Date
Description
V
Jun-
2015
▪ Addition of RX3i CPE330 (new product) and related Ethernet considerations.
▪ Update of Energy Pack Section 4.11.3 to include ACC402 and compatibility matrix.
▪ Addition of HART
®
Pass Through feature (see page 10).
▪ Addition of CPU Comparison Charts (Section 2.2 and Section 2.3).
▪ Update of Communications Section (Chapter 5). Added
▪ RSTi-EP CPE100/CPE115 : RS232, RS485 Signals
▪ Serial Port Electrical Isolation.
▪ Removed original Chapters 5-11 (chapters dealing with CPU programming) and Chapter 14
(Diagnostics). These are now in PACSystems RX7i and RX3i CPU Programmer’s Reference
Manual, GFK-2950 (Chapters 2-8 and Chapter 9 respectively).
U
Nov-
2014
▪ New Section, A-3.6 for EGD Sweep Impact for RX3i CPE302/CPE305/CPE310 and RSTi-EP
CPE100/CPE115 Embedded Ethernet Interface.
T
Oct-
2014
▪ Support for OPC UA using embedded Ethernet port in CPE305/CPE310 with CPU firmware
8.20.
▪ Support for Ethernet Global Data (EGD Class 1) using embedded Ethernet port in
CPE305/CPE310 with CPU firmware 8.30 Sweep impact of EGD on Embedded Ethernet
interface. Direct replacement for S90-30 IC693CPU374.
▪ New communications capabilities provided by:
o IC695PNS001 – PROFINET Scanner Module
o IC695GCG001 – Genius Communications Gateway via PROFINET
o IC695EDS001 – Ethernet based DNP3 Outstation
RS-232 Signals
RS-485 Pins
Signals
TX
Y
TX+
RX
Z
TX-
GND
A
RX+
RTS
B
RX-
CTS

GE PACSystems RX7i Specifications

General

Brand	GE
Model	PACSystems RX7i
Category	Controller
Language	English