GE
Sensing
DECLARATION
OF
CONFORMITY
DOC-0012, Rev. A
We, GE Sensing
1100 Technology Park Drive
Billerica, MA 01821
USA
declare under our sole responsibility that the
Moisture Monitor™ Series MMS35IS Moisture Analyzer
PM880 Portable Hygrometer
to which this declaration relates, are in conformity with the following standards:
• EN 60079-0: 2007
• EN 60079-1: 2004
• EN 50020: 1994
• EN 50284: 1999
• II 1 G EEx ia IIC T4:
PM880: Baseefa02ATEX0191 (Baseefa, Buxton, Derbyshire, UK - NoBo 1180)
MMS35IS: ISSeP01ATEX035X (ISSeP, B7340 Colfontaine, Belgium - NoBo 492)
• EN 61326-1: 2006, Class A, Table A.1, Portable Equipment
(For EN 61010-4-3, the MMS35IS meets performance criteria A and, in a limited
number of frequencies, performance criteria B per EN 61326)
• EN 61326-2-3: 2006
Other standards used:
• EN 50014: 1997 +A1, A2:1999
following the provisions of the 2004/108/EC EMC and 94/9/EC ATEX Directives.
Where products were initially assessed for compliance with the Essential Health and Safety
Requirements of the ATEX Directive 94/9/EC using earlier harmonized standards, a
subsequent review has determined that “technical knowledge” is unaffected by the current
harmonized standards listed above.
The units listed above and any ancillary equipment supplied with them do not bear CE
marking for the Pressure Equipment Directive, as they are supplied in accordance with
Article 3, Section 3 (sound engineering practices and codes of good workmanship) of the
Pressure Equipment Directive 97/23/EC for DN<25.
Billerica - August 2010
Issued
Mr. Gary Kozinski
Certification & Standards, Lead Engineer
To Next Page
Loading...
