Chapter 1. Getting Started
Model PM880 Portable Hygrometer User’s Manual 9
1.4.1 Selecting Probe Type (cont.)
4. At Type, press [ENTER] to open the drop-down list of probe types.
Note: If you do not know the probe type, refer to the Calibration Data
Sheet.
5. Use the arrow keys to scroll to the desired selection and press [ENTER].
6. Press [F3] (OK) to exit.
Next, do one of the following:
• If you are using an M or TF Series probe, proceed to Entering
Calibration Data on the next page.
• If you are using an MIS or an MISP2 Probe, proceed to Displaying
Measurements on page 15.
Note: If you have an MIS probe that was sent back to the factory for
calibration without the electronics module, you need to enter
calibration data as described in Entering Calibration Data on
page 10.
To Next Page
Loading...
