DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
Chapter 3 - System Setup 3-35
PRELIMINARY
Section 3-8
Connectivity Setup
NOTE: If connected to a stand-alone network (Peer-to-Peer network with a Venue Fit™ scanner, and an
optional network printer), you should use default delivery settings.
3-8-1 Introduction
To be able to use the network functions when connected to a hospital network, the Venue Fit™ must
have a proper network address.
• Before you can set up the Venue Fit™ , you need to collect some information.
• The Worksheet (see sample Connectivity Installation Worksheet ) can be used for gathering this
information.
• Typical source for this information is the network administrator.
To Next Page
Loading...
