DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
3-14 Chapter 3 - System Setup
PRELIMINARY
3-4-3-4 Peripheral/Accessory Interface Panel
The figure below shows a view of the Venue Fit™ ultrasound unit rear panel showing external
peripheral/accessory connectors.
1 Ethernet LAN connector — 1000 Base-TX Ethernet IEEE 802.3 (1.5kV insulation)
2 USB 3.0 connector x3 (not insulated)
3 HDMI connector (not insulated)
3-4-3-5 EMI Protection
The Venue Fit™ has been designed to minimize the effects of Electro-Magnetic Interference (EMI).
Many of the covers, shields, and screws are provided primarily to protect the Venue Fit™ from image
artifacts caused by this interference. For this reason, it is imperative that all covers and hardware are
installed and secured before the Venue Fit™ is put into operation.
See EMI Limitations for more information about EMI protection.
Figure 3-6 View of the Venue™ Peripheral/Accessory Interface Panel
To Next Page
Loading...
