DIRECTION 5854713-100, REVISION 2
VENUE FIT™ SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-17
PRELIMINARY
4-3-5 Peripheral Checks
4-3-5-1 Printer Checks
The printer is controlled from the Print button on the Venue Fit™’s application main screen.
Table 4-20 outlines the steps for performing Printer checks.
4-3-5-1-1 Windows Print Test Page
This checks that the printer is correctly installed and hooked up at the Windows level.
1) On the Venue Fit™application main screen, tap: Settings > Config > Connectivity > Additional
Outputs.
Table 4-20 Printer Checks
Step Task Expected Result(s)
1
When scanning in 2D Color
Mode, press Freeze to stop
image acquisition.
Image scanning stops with the last
picture on the screen.
2
Press Print on the Operator
Panel
The image displayed on the screen is
printed on the assigned printer.
3
Check if the print quality on the
pictures from both printers are of
expected quality.
To Next Page
Loading...
