DIRECTION 5854713-100, REVISION 2 VENUE FIT™ SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-51
PRELIMINARY
Select Reboot Venue Fit Scanner. The following message appears:
Figure 8-86 Venue Fit™ Update Process- Flash Eject Dialog Box
8.) Disconnect the SW installation media and tap OK in the message box.
In the Confirmation dialog box that appears:
Figure 8-87 Venue Fit™ Update Process- Confirmation Dialog Box
9.) Tap Yes to continue the reboot.
10.)Continue with Venue Fit EZ Config Setup Wizard:
• Run Venue Fit™ EZ Config Setup Wizard
Perform the checks listed in Tab le 8 - 3 6 - Software installation section
To Next Page
Loading...
