DIRECTION 5854713-100, REVISION 2 VENUE FIT™ SERVICE MANUAL
8-54 Chapter 8 - Replacement Procedures
PRELIMINARY
8.) The system will reboot automatically and the Venue Fit SW reload window will be displayed.
9.) Select Reload Venue Fit SW. The software reload process will start.
10.)Once the process is complete, The Venue Fit SW reload window will be displayed again.
11.)Select Reboot Venue Fit Scanner.
12.)The system will reboot.
13.)Continue with Venue Fit EZ Config Setup Wizard:
Figure 8-92 Venue Fit SW Reload
• Run Venue Fit™ EZ Config Setup Wizard
Perform the checks listed in Tab l e 8-3 6 - Software installation section
To Next Page
Loading...
