GE Vivid q N - Page 125

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-53
NOTE: Installation of Carto3 and the required VGA splitter (to connect to the Vivid q N) shall be done
by the BWI field engineer according to the BWI manuals and instructions.
NOTE: Vivid q N-to-Carto3 VGA Cable Installation:
A GE Field Service Engineer must be present when connecting the VGA cable (top right in
Figure 3-52) between the Vivid q N system and the GE Video Splitter/Isolation box.
1.) Connect the VGA cable (Figure 3-52) to the VGA input port at the rear of the VGA splitter
(see Figure 3-53 and Figure 3-54).
Connect the other end of the cable into the Vivid q N system’s VGA output port.
2.) Plug the VGA Splitter power cable (Figure 3-52) into the power socket on the rear of the VGA
Splitter (see Figure 3-53 and Figure 3-54).
WARNINGWARNING
To avoid possible electrical shock to user or patient, the Vivid q N should be connected to the
Carto3 only by using the Isolated VGA Splitter.
Figure 3-53 VGA Splitter - Rear View
Connect VGA CableConnect Power Cable