GE Vivid q N - Page 126

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-54 Section 3-7 - Completing the Hardware Installation
Plug the other end of the power cable into the mains power wall outlet.
3.) Connect the necessary DVI cables (Figure 3-52) to the VGA Splitter DVI output ports (as required
for further connection to other DVI devices). Refer to Figure 3-54, above.
4.) When connecting the DVI output cable to an external monitor, press V-Out on the Vivid q N system
console.
The screen shown in Figure 3-55 is displayed:
5.) Under Multiple Display, activate the Intel(R) Dual Display Clone radio button.
Monitor is now selected as the Secondary Device, as shown in Figure 3-55.
Figure 3-54 Connections to VGA Splitter
Figure 3-55 Selecting Dual Screen Display Option
Interface Connections