GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-34 Section 8-3 - Internal Component Replacement Procedures
8-3-2-4 TR32 and RFI Boards Removal Procedure
1) Remove the bearing handle, as described in the "Bearing Handle Removal Procedure" on page 8-2.
2.) Remove the Control Panel and Keyboard, as described in the "Control Panel and Keyboard
Removal Procedure" on page 8-10.
3.) Loosen the eight screws that secure the TR32 and RFI Boards to the Bottom Assembly, as shown
in Figure 8-36 below.
4.) Remove the eight screws - see Figure 8-37.
5.) Disconnect the PCI cable flex (BEP-to-RFI) from the cable connector on RFI Board as shown in
Figure 8-36 Loosen Screws that Secure TR32 and RFI Boards to Bottom Assembly
Figure 8-37 Removing the Screws
To Next Page
Loading...
