GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-56 Section 8-3 - Internal Component Replacement Procedures
3.) Slide to open the two connector latches and disconnect the LCD Flex ribbon cable from BEP - refer
to Figure 8-65.
4.) Unscrew and remove the four screws (two on either side - as shown in Figure 8-66) that secure the
Rear Cover and Latch Assembly to the Bottom Assembly.
5.) Detach the Rear Cover and Latch Assembly from the Bottom Assembly and remove.
Figure 8-65 Connector Latches
Figure 8-66 Rear Cover and Latch Assembly Securing Screws
To Next Page
Loading...
