GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-57
8-3-8-5 AUO LCD Display Installation Procedure
NOTE: When performing this procedure, care must be taken to correctly attach the Display Frame on the
Bottom Assembly hinges.
NOTE: Prior to inserting the hinge securing screws in their respective locations, apply a coating of
Loctite 402 glue to each of the hinge screws (supplied).
1.) Protect the Bottom Assembly with a protective cloth, as shown in Figure 8-67.
2.) Check that there is a coating of Loctite 402 on each of the screw threads.
3.) Carefully position the AUO LCD Display Assembly on the Bottom Assembly hinges and secure the
LCD Display Assembly in position with the four screws provided - two each side, see Figure 8-66.
Note: Check that there is a coating of Loctite 402 on the screw threads, but do not tighten the
screws completely - see Figure 8-68.
Figure 8-67 Protecting the Bottom Assembly
Figure 8-68 Mounting the AUO LCD Display Assembly onto the Bottom Assembly
To Next Page
Loading...
