GE Vivid q N - Page 567

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-61
7.) Disconnect the LCD flex [1] from the rear panel of the LCD Display and remove - Figure 8-71.
8-3-9-5 AUO LCD Cable and Flex Installation Procedure
NOTE: The numbers shown in square brackets correspond to the numbers listed in Table 8-3 on page 8-59.
1.) Connect the LCD Flex to the LCD as shown in Figure 8-71.
2.) Thread the Flex Board cable through the Display Flex Cover [6] making sure that the Display Flex
Cover is correctly orientated as shown in Figure 8-72.
3.) Thread the Flex Board cable through the ferrite core [7] and secure the ferrite with a strip of Kapton
tape - Figure 8-72.
4.) Connect the Inverter Flex Board cable [2] to the Flex Board [4], then connect its other end to the
LCD Backlight Inverter board [5] - Figure 8-70.
5.) Connect the LCD Backlight Inverter board [5] to the AUO LCD cable [3] - Figure 8-70.
Figure 8-71 LCD Flex Connected to LCD Rear Panel
Figure 8-72 Flex Board Cable Threaded through Flex Board Cover and Ferrite
6
7