GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-62 Section 8-3 - Internal Component Replacement Procedures
NOTE: To install the AUO LCD display in the rear cover (the system lid), the flex cable must be prepared by
folding as shown in Figure 8-73. Folding the flex cable in this manner enables the LCD panel to lie flat
in the lid housing.
6.) Fold the LCD flex as shown in Figure 8-73.
7.) Connect the LCD flex to the Flex Board.
The sub-assembly parts should now be as shown in Figure 8-74.
Figure 8-73 LCD flex fold
Figure 8-74 Sub-assembly showing Parts Assembled
Tip: Fold here at +/- 20 cm from
right end
20 cm
To Next Page
Loading...
