GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-63
8.) Place the AUO LCD Display in position in the system’s top rear cover (the system lid) - Figure 8-75. .
9.) Position the LCD Backlight Inverter board on the retaining pins located in the system’s rear cover.
10.)Secure the Flex Board with the two retaining screws as show in Figure 8-75.
11.)Refit the AUO LCD Display in the system’s top rear cover as described in the "AUO LCD Display
Installation Procedure" on page 8-57.
12) Check that the LCD Display can be tilted upwards and downwards, and that it holds its set position.
13.)Proceed to perform the following functionality tests:
- "SafeLock Cart - Grounding Continuity" on page 10-22 - only if the Vivid q N system is
currently mounted on the SafeLock cart
- "SafeLock Cart - Chassis Current Leakage Test" on page 10-24
- "Full System Test" on page 7-10
Figure 8-75 AUO LCD Display located in the Vivid q N Top Rear Cover
To Next Page
Loading...
