GE Vivid q N - Page 586

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
8-80 Section 8-4 - SafeLock Cart Components Replacement
NOTE: The movement should be smooth and there must be no pinching of the cables.
Slide the top-shelf up and down a number of times and check that the cables do not disturb the
up-down movement of the cart’s top-shelf - see Figure 8-96.
12.)Return the Upper Rear Cover as described in Service Manual Direction R2423163-100, Revision
3, Chapter 8, section 8-4-3-4.
13.)Return the Upper Cover (rear) and Lower Cover (rear) of the SafeLock Cart as described in "Upper
Cover (Rear) Installation Procedure" on page 8-66 and "Lower Cover (Rear) Installation Procedure"
on page 8-73.
14.)Once more, slide the top-shelf up and down a number of times and check that the movement is
smooth and that there is no interference of the cables with the up-down movement of the cart’s
top-shelf.
15) Proceed to perform the following functionality tests:
- "SafeLock Cart - Grounding Continuity" on page 10-22
- "SafeLock Cart - Chassis Current Leakage Test" on page 10-24
Figure 8-96 Fully-raised (left) and Fully-lowered Positions (right)