General Dynamics C4 Systems URC-200 (V2)
14
Cables
In addition to the cables shown below, other cables for data and audio connections, remote control,
power, and RF/Antenna connections are available. Contact General Dynamics Customer Service
for more information.
• LSCA-103A and LSCA-110 Cable Assemblies
The LSCA-103A and LSCA-110 are used to connect to the remote PTSH-
104 Amplified Speaker assembly.
• PTKY-103 CRYPTO Cable Assembly
The PTKY-103 is a shielded, three-foot long water-tight cable assembly used
to connect the transceiver to a COMSEC device for secure operation.
Remote Control Units
Two remote control units are available. The UEC-120 controls one transceiver, and the UEC-220
can control one or two transceivers.
RF Power Amplifier
Two versions of the RF power amplifier are available: the UPA-55 and UPA-55H.
The UPA-55 provides up to 50 Watts average power at 90% modulation (35.6 Watts CW) RF AM
power and 50 Watts FM output power with harmonics ≤ -60 dBc AM or FM.
The UPA-55H provides up to 50 Watts RF FM and 30 Watts average power at 90% modulation
(21.4 Watts CW) AM output power with harmonics ≤ -60 dBc FM. ≤ -80 dBc AM.
Both versions operate over the VHF frequency range of 115 to 174 MHz, and the UHF frequency
range of 225 to 420 MHz (FM mode, AM mode up to 400MHz).
Antennas
In addition to the antennas shown in this manual, a variety of single, dual and tri-band antennas are
available for operation with the URC-200 (V2) Transceiver. Applications include mobile, ManPack
and base station installations. Mounting brackets are supplied in some cases. Contact General
Dynamics Customer Service for more information.
• UVL-100 ManPack antenna.
Antenna covers 30-110 MHz.
• UVL-150 HF rugged spring-loaded antenna for vehicular applications.
Antenna covers 30-90MHz.
• UVU-115 15" Whip Antenna for vehicular applications.
Antenna covers 115MHz - 420 MHz.
To Next Page
Loading...