Genie Z Series User Manual

Maintenance Manual April 2018
Programmed Maintenance Procedures
140 S
®
Booms • Z
®
Booms Part No. 1268489GT
P1-1
Perform Engine Maintenance –
1000 Hours
Engine specifications require that this procedure be
performed every 1000 hours.
Required maintenance procedures and additional
engine information are available in the
manufacturer's manuals. Refer to Specifications,
Engine Operator and Maintenance Manuals.
Continental TME27
• Spark plugs - replace
• O2 sensors - replace
Cummins Models
• Drive belt tension - measure
• Drive belt - inspect
GM 3.0L
• Fan belt - inspect/replace
• Radiator hoses and clamps - check
• PCV system - check
Deutz Models
All Models:
• Fuel system primary filter (water separator)
element – replace
• Fuel system secondary filter – replace
• Hoses and clamps – inspect/replace
• By-pass oil filter - replace
• Engine mounts - inspect
• Glow plugs - check
• V-belts - re-tension/renew
• Cold starting device (if equipped) - check
• Battery and cable connectors - check
• Engine valve lash – inspect/adjust
D 2.9 and TD 2.9 Models:
• Coolant (additive concentration) - check

Genie Z Series Specifications

General

Lift Capacity	500 lb (227 kg) to 660 lb (300 kg)
Gradeability	30%
Power Source	Diesel, Electric
Capacity	500 lb (227 kg) to 1, 000 lb (454 kg)
Drive System	4-wheel drive
Tire Type	Solid
Steering	2-wheel or 4-wheel