796688 (4188-657)_i2 _06/03
3
To identify MCP required to be fire tested on a weekly
test .................................................................................34
To exit Fire test mode (assuming Fire Test is On).......34
To edit a zone label .......................................................35
To put a zone in and out of Test mode ........................36
To enable or disable a zone.......................................... 37
To put a zone in false alarm rejection mode ................38
To select 2-detectors or 2-zones coincidence detection39
To assign a zone to trigger a sector .............................40
To view devices in a selected zone ..............................41
To enable / disable a device .........................................42
To edit a device label.....................................................43
To assign a device to a zone ........................................44
To set auxiliary relay operation (eg to operate with fire,
fault, disablement, pre-alarm or off)..............................45
To set fire routing output operation (eg change
activation type, delayed operation of relay and
monitoring).....................................................................46
To set fault routing operation (eg activation type) ........47
To view / enable or disable alarms sounders...............48
To set weekly alarm test reminder message (eg day
and message)................................................................ 49
To set / view maintenance reminder message ...........50
To set Delay and Verify functions................................51
To set the Local input....................................................52
To set time and date .....................................................53
To change an existing password..................................54
To set up the access level for Cancel buzzer and
Display test controls ......................................................55
To edit User text ............................................................56
To clear logs ..................................................................57
To save the loop map....................................................57
To reset all access codes to factory settings................58
To reset the panel configuration to factory settings .....58
To reset all configurations and labels to factory settings59
To view diagnostic data.................................................59
Appendix – Description of Controls and indicators.................60
Controls..........................................................................61
Light indications.............................................................62
Message description list for System 800......................64
Product data.............................................................................69
Notes........................................................................................70
To Next Page
Loading...