64
796688 (4188-657)_i2 _06/03
Message description list for System 800
Any service and maintenance work on the panel or system must be carried out by a
trained maintenance engineer from the fire alarm servicing organisation.
Message displayed Description and checks
12V supply failed
The panel 12V supply has failed.
12V supply OK
The panel 12V supply is OK.
24V supply failed
The panel 24V supply has failed.
24V supply OK
The panel 24V supply is OK
5V supply failed
The panel 5V supply has failed.
5V supply OK
The panel 5V supply is OK
Access codes
reset
The access codes have been manually reset to the factory
default settings.
Access denied!
The command or menu option selected cannot be executed at
the current access level. Enter a higher access level.
Access level
changed
The access level has changed.
Alarms silenced
The fire alarms in the system have been manually silenced.
Alarms sounded
The fire alarms in the system have been manually activated
and are sounding.
Allocation Tx
Error
The panel is not getting a response when communicating with
a device on the loop circuit.
All zones in test
All zones of the system have been manually put into a weekly
fire test state.
All zones out of
test
All zones of the system have been taken OUT of weekly fire
test.
Batteries
discharged
The panel 12V 7Ahr batteries are discharged.
Replace batteries in the panel.
Batteries
disconnected
The panel 12V 7Ahr batteries have been disconnected.
Battery fault
cleared
The battery disconnection or discharge fault has cleared.
Cannot put all
zones into test
The panel is in a fire condition and a manual attempt to put all
zones into weekly fire test state is rejected.
Ensure the panel is not in fire condition before putting all zones
into test state.
Cannot test fire
input
The panel is in fire condition, therefore manual attempt to test
the fire input is rejected.
Charger fault
The battery charger in the panel has developed a fault.
Check the battery circuit wiring and battery fuse.
Charger fault
Cleared
The fault associated with the battery charger circuit on the
electronic module has been cleared.
Class change Off
The class change input has been switched off.
Class change
operated
The class change input has been operated and the sounders
in the system are active.
Clock settings
saved
Changes made to the clock settings have been saved.
Customer mode
entered
The customer mode has been entered to allow access to
menu options under level-3.
Data saved
The changes made to the system configuration has been
saved.
Day mode data
saved
Changes made to the day mode settings have been saved.
To Next Page
Loading...