Gent System 800 - To Set Delay and Verify Functions

796688 (4188-657)_i2 _06/03
51
To set Delay and Verify functions
A2
min
Press to increment
0 to 9 minutes.
Select
Press to increment
from 0 to 59 seconds.
Press to increment
from 1 to 8 hours.
If 0 hours is entered
then the Dela
y
mode
is disabled
Select
A3
A2
Press to select field [ ]
Previous Next
[D a
y
mode dela
y
]
(extended Verify delay)
[D a
y
mode timeout period]
(Verification Delay mode timeout)
Press to select
seconds field [ ]
Next
1
2
3
P1
EEPROM enable
1
2
3
P1
EEPROM enable
The in the system can be delayed on a fire condition.
The can be confi
g
ured up to 9 minutes 59 seconds
(factory set to 30 seconds). This delay is imposed on the
alarm sounders at the be
g
innin
g
of a fire condition, providin
g
the Delay
facility is active with the delay LED lit.
The is an extended alarm delay to verify a fire alarm.
alarm sounders
Initial dela
y
Da
y
mode dela
y
This delay value can be up to 9 minutes 59 seconds. Note this value is
the total delay duration from the start of a fire condition. It is made active
on pressin
g
the Verify button when initial Delay is active and delay
LED is lit. The is the duration over which
Delay and Verify functions can be operated.
Da
y
mode timeout
p
eriod
Press to increment
0 to 9 minutes.
Select
Press to increment
from 0 to 59 seconds.
A2
[Initial dela
y
]
(initial Verify delay)
Press to select
seconds field [ ]
Next
Initial dela
y
30s factor
y
default
Da
y
mode dela
y
Start of
alarm
Maximum alarm dela
y
9min 59sec
Alarm dela
y
o
p
eration