Geotech GA5000 - View Data

OMGA5KN4.4 GA5000 gas analyser
Page 40 of 113  Copyright Geotech
2) Select ‘Key 2 – Gas Check’ and the following menu is displayed:
3) For more information about the Gas Check Menu please refer to section 9.0 –
Calibration.
4) Select soft-key ‘Exit’ to exit operation settings and return to the main screen.
7.4.3 View data
This option enables the operator to view the readings collected and stored
on the instrument. Readings many be downloaded to the optional Gas
Analyser Manager (GAM) software if further analysis is required.
1) Select the ‘Menu’ button on the front of the analyser to display the ‘Device Settings’
menu. Press the soft-key to display ‘Operation Settings’.
2) Select ‘Key 3 – View Data’ and the following screen is displayed:
View data
3) Toggle through the reading by selecting ‘Key 4 – Scroll left’ and ‘Key 6 – Scroll right’
on the analyser. Select ‘Key 2 – Page up’ and ‘Key 8 – Page down’ to page through
the auxiliary channels listed.
4) Select the soft-key ‘Filter’ to filter the data by sample point ID, or specify before or
after date. Press the soft-key ‘Exit’ to exit the filter menu and return to the ‘View
Data’ screen.