GA5000 gas analyser OMGA5KN4.4
Copyright Geotech Page 41 of 113
Filter data
5) Select the soft-key ‘Delete’ followed by the appropriate soft-key to delete a single
reading or all filtered readings. Press soft-key ‘Cancel’ to cancel the deletion request.
6) Select the soft-key ‘Exit’ to exit the view data screen.
7.4.4 Set alarms
This option enables the operator to define the conditions for which an
alarm/target will be triggered. These conditions apply to the general
operation of the instrument and are not ID specific. A summary of the
alarm settings can be found in ‘Key 3 – Summary’.
Types of alarms
Common Alarms – Are non-ID specific alarms which apply to all the readings taken
with the analyser.
ID specific alarms – Are ID specific, i.e. they will only trigger when a certain Id is
being used.
Tuning/targets – You can also set targets for your gas channels, these will highlight
gas channels green as oppose to when they alarm (yellow). These can be common or
ID specific.
Setting up alarms/targets
1) Select the ‘Menu’ button on the front of the analyser to display the ‘Device Settings’
menu. Press the soft key to display ‘Operation Settings’.
To Next Page
Loading...
Need help?
General
