Getting Started 1-13
Using the Tether
NOTE: Attach the tether for the stylus to the device before attaching the
hand strap.
A tether is provided for attaching the stylus to your device.
1. Insert one of the tether’s loop ends through the hole of the stylus (as
indicated by n below). Then, insert the other end through the first loop
(as indicated by o below) and pull it tight.
2. Insert the other loop end to the holder on the device (as indicated by n
below). Then, insert the stylus end through the loop (as indicated by o
below) and pull it tight.
To Next Page
Loading...
