| CARDIOHELP System | 5 Service Interfaces | 99 |
Service Manual | 3.3 | EN | 05
Copyright Maquet Cardiopulmonary GmbH
NOTE
Perform the installation of the CARDIOHELP hardware on every available USB connection of your laptop.
The installation of the CARDIOHELP hardware is only valid for the appropriate USB connection.
1 Start the CARDIOHELP and connect it to the laptop with the USB
cable.
"Welcome"
▶ The installation wizard starts automatically.
2 Select the option “Yes, just this time”.
3 Click on the [Next] button.
4 Select the option “Install software from a list or appointed
source” (advanced user).
"Installation wizard"
5 Select the driver from the hard disk and install them.
▶ C:\ProgramFiles\CommonFiles\Maquet\Driver
6 Click on the [Next] button.
▶ Searching for hardware.
"Installation wizard" screen
7 Click on the [Continue installation] button.
"Installation wizard" screen
5.5.3 Installing at Windows 7
At the first USB connection between the CARDIOHELP and the laptop, the CARDIOHELP hardware must
be installed on the laptop.
To Next Page
Loading...
Need help?
General
