To Next Page

To Previous Page

ProfiLux 4 Resource Guide

EN 2018-13-11 63

React to a feed pause

 See How to setup feed pause functions

 Plug in return pump to the assigned Powerbar outlet.

Shut down pump if sump water level gets too low

In order to turn OFF the return pump to prevent it from running dry, you will need a GHL float

or optical sensor. This sensor is what will trigger the pump to turn OFF.

 See How to setup leakage detection

 Plug in return pump to the assigned Powerbar outlet.

Combine Feed Pause and Leakage Detection

If you wish to have the return pump react to more than 1 of the above functions, you can do so

with Programmable Logic. This option will allow you to tie-in multiple functions to a single

Powerbar outlet.

 See How to setup feed pause functions and ONLY follow

CREATING THE FUNCTION

steps

 See How to setup leakage detection and ONLY follow

CREATING THE FUNCTION

steps

 See Combining Feed Pause and Leakage Detection

 Plug in return pump to the assigned Powerbar outlet.

Control flow rate via 1-10V interface

If you have a 1-10v compatible return pump, you can have the ProfiLux 4 control the pump’s

flow rate. To do this, you will need a GHL-dedicated control cable from the pump manufacturer.

If one is not available, you can still control the pump by using our Breakout-Box 1-10V

accessory (PL-0067).

 See How to setup 1-10V pump control

React to a maintenance mode

The maintenance mode is a feature that temporarily turns OFF or ON specific Powerbar outlets.

This feature can also be used to ramp down a 1-10v compatible return pump that is connected

to the ProfiLux.

 See How to setup maintenance modes

Other manuals for GHL ProfiLux 4

Questions and Answers:

Need help?

Do you have a question about the GHL ProfiLux 4 and is the answer not in the manual?

General